Reattaching the front and back pads to the headset

Always make sure that the front and back pads are attached to the headset.

While holding the visor with one hand, pull up the band.
Starting from the middle, align the front pad tabs with their corresponding slots on the band, and then press along the front pad. You may need to gently bend the ends of the front pad to align the outermost tabs with the slots on the band.

Make sure to minimize the gap between the pad and the band and that all tabs are fully locked into place.
Align the back pad tabs with their corresponding slots on the band, and then press along the back pad to reattach.
Note: Check that the headset cable strip is properly attached. For details, see Reattaching the headset cable strip to the back pad.
You'll hear a click when the tabs are inserted.

Make sure to minimize the gap between the pad and the band.

Was this helpful? Yes No

Submit

Thank you! Your feedback helps others to see the most helpful information.